7. Repeat steps 3-6 on the right.
8. Use the creases you just made to form three nested rabbit ear folds.
9. Pinch the flap in half and swing it over to the right.
Online collections
monedastodas.com
All collections » Origami » Spenjurmunni
Designed by Robert J. Lang
Copyright ©1999. All Rights Reserved.
Any resemblance between this origami design and a character from any irritating-sound-producing videogame, overpriced trading card, or mind-numbing, poorly-animated TV show, is purely coincidental.
3. Fold the bottom point up so that its edge hits the right corner.
4. Fold the horizontal edge down so that it aligns with the folded edge.
5. Fold the edge back up so that it aligns with a folded edge.
10. Fold the two flaps down and flatten the model firmly.
7. Repeat steps 3-6 on the right.
8. Use the creases you just made to form three nested rabbit ear folds.
9. Pinch the flap in half and swing it over to the right.
11. Bring the long flap to the front. This flap will be the tail.
12. Fold the top flap down.
13. Fold the flap back up. Note that the crease hits the centerline at the same point as the tail
14. Fold the top flap down so that its tip aligns with a hidden horizontal
crease.
15. Bring the raw edges to the front on both left and right.
17. Fold the flaps out to the sides.
18. Fold the top edge down along a crease that runs from corner to corner.
19. Pleat the ears at the top of the model.
20. Mountain-fold four flaps to the rear.
21. Valley-fold the corners.
tail. Pleat the tail like a lightning
23. Turn the model over.
24. Finished model. Color on a face as shown in the next figure.
25. Finished Spenjurmunni, taking a peek at you.
Download PDF file with this instructions for printing